![delta rockwell table saw blade guard delta rockwell table saw blade guard](https://www.thesharkguard.com/wp-content/uploads/2019/07/IMG_72881.jpg)
This can happen in different ways, the most common is from reaching over the blade to grab a cutoff and dropping it or dragging it over the blade which will cause it to shoot back at you. That’s partially correct, but its main purpose is to prevent wood from falling on a spinning blade.
![delta rockwell table saw blade guard delta rockwell table saw blade guard](https://i.redd.it/0qkwjvt5126z.jpg)
Most people think the primary purpose of a blade guard is to keep your fingers safe. It will dramatically reduce the chance of kickback. You may need to remove it when using dado blades, but for all other cuts, make sure it’s in place. I also want to stress that using a riving knife is non-negotiable and I believe it is the single most important safety feature on a table saw. I think demonstrating safe procedures with that in mind is important. Especially if you are new to using a table saw, I recommend using every safety feature it has.īut in the real world, I have to acknowledge that many, perhaps most people are not using blade guards. It would be wildly irresponsible for me to do so.
![delta rockwell table saw blade guard delta rockwell table saw blade guard](https://i.ebayimg.com/images/g/rF8AAOSwT9NhgYLf/s-l640.jpg)
I want to start out by saying that I do not advocate that you use a table saw without a blade guard. Two of those were in a high-end shop with industrial equipment, where the blade guard is used to assist in better dust extraction. Out of fifty, I found three that seem to regularly use a blade guard. I did a quick check on fifty of the biggest woodworking channels that I subscribe to.